Vimar ELVOX 13F3 Manual De Programación página 7

13F3, 13F3.B - 13F5, 13F5.B
Parameters
The standard configuration can be changed using the buttons on the electronic unit (standard configuration) or the programmable time switch art. 950C or the interface
art. 692I/U connected to a PC on which the SaveProg software has been installed (for the advanced configuration).
The two configuration types are explained below.
Standard programming parameters:
Parameter
- Entrance panel ID
- EEPROM reset
- Single/double buttons
- Answer time
- Conversation time
- Self-start time
- Lock time
- F1 Time
- F2 Time
- Entrance panel chime repetition
- Lock block
- Monitor/interphone chime cycles
- Disable SLAVE panel search
- Horizontal Bus
- Button remapping
- Monitor packages
- Common locks
Parameters for standard and advanced configuration using art. 950C or SaveProg software for PC:
- Message language
- Entrance panel ID
- Installation
- First button ID
- Button remapping
- Single/double buttons
- Programming password
- Answer time
- Conversation time
- Self-start time
- Lock time
- F1 time
- F2 time
- Lock block
- Enabling
- Entrance panel chime repetition
- Handsets chime cycles
- Consumer unit push-button
- Audio call push-button
- Shared locking
- Shared F1
- Shared F2
- Disable SLAVE panel search
- Self-start disabling
- Self-start sequence
Default value
(Master)
Single row
30 seconds
120 seconds
10 seconds
1 secondo
1 secondo
1 secondo
Enabled
Disabled
2
YES (disable)
NO
Hardware
ON
No association
Local
(Master)
Vertical
1
Hardware
Single row
654321
30 seconds
120 seconds
10 seconds
1 second
1 second
1 second
No
No assignment
Yes
2
No association
No association
No assignment
No assignment
No assignment
YES (off)
No
No assignment
EN
7