Worx WG505E Traducción De Las Instrucciones Originales página 9

the housing is undamaged
and that guards and
screens are in place.
Replace worn or damaged
components in sets to
preserve balance. Replace
damaged or unreadable
labels.
g) Before use, check the
supply and extension cord
for signs of damage or
aging. If the cord becomes
damaged during use,
disconnect the cord from
the supply immediately.
DO NOT TOUCH THE CORD
BEFORE DISCONNECTING
THE SUPPLY. Do not use
the machine if the cord is
damaged or worn.
h) Keep extension cords away
from moving hazardous
parts to avoid damages to
the cords which can lead to
contact with live parts.
i) If an extension cord is used
make sure it is for outdoor
use and marked as such.
The recommended size of
extension cord is not lighter
than 1 mm
2
3) Operation
a) Before starting the machine,
make certain that the
feeding chamber is empty.
b) Keep your face and
body away from the feed
intake opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
All-in-One Blower/Vac/Mulcher
.
chamber, discharge chute,
or near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand
at a higher level than the
base of the machine when
feeding material into it.
e) Always stand clear of
the discharge zone when
operating this machine.
f) When feeding material into
the machine be extremely
careful that pieces of metal,
rocks, bottles, cans or other
foreign objects are not
included.
g) If the cutting mechanism
strikes any foreign
objects or if the machine
should start making any
unusual noise or vibration,
immediately shut off the
power source and allow
the machine to stop.
Disconnect the machine
from the supply and take
the following steps before
restarting and operating the
machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii) check for and tighten any
loose parts.
h) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback of
material through the intake
opening.
9
EN