Sauder 416511 Manual De Instrucciones página 12

Step 8
Fasten the UPPER PLINTHS (O) to the END
å
MOLDINGS (S and T). Use two BLACK 1-1/4"
FLAT HEAD SCREWS (7S).
Fasten the SIDE MOLDINGS (M) to the END
å
MOLDINGS (S and T). Use four BLACK 1-1/4" FLAT
HEAD SCREWS (7S).
NOTE: There are no pre-drilled holes in the SIDE
å
MOLDINGS. The SCREWS will tighten into the groove.
The END MOLDINGS
will set in from the edge.
Page 12
S
M
O
BLACK 1-1/4" FLAT HEAD SCREW
416511
T
O
Curved edge
7S
(6 used in this step)
www.sauder.com/services
M