Torin TRA8205B Manual De Propietario página 11

RAISING A VEHICLE
1. Securely chock and block (stabilize) the load you are going to lift. This will prevent it from rolling
or shifting as you lift it.
2. Keep the handle against the steel standard (column) when not lifting or lowering.
before moving the reversing latch. This will prevent the handle from moving up
and down rapidly, which could cause serious injury or death if it comes into
contact with any part of your body. Always keep your head out of the travel path
of the handle.
3. Place the jack's base plate securely on a firm, level, and dry surface with the steel standard
(column) pointing vertical.
Lift the reversing latch until it locks in the "UP" position.
4.
5. Grasp the handle or the handle socket and raise the lifting mechanism until the nose is
completely and securely under the load.
6. Grasp the handle firmly with both hands. Carefully pump the handle up and down to raise the
load. Do not use an extension on the handle.
•
The load will be raised on each DOWN stroke of the handle.
•
Watch the load and the jack carefully. Stop jacking if either one starts to move. Do not continue
raising the load unless it is safe to do so. When safe, stabilize and block the load.
7. When the load is raised to the desired height, place the handle in the upright position against
the steel standard (column).
8. Block the load securely with jack stands.
9. Lower the load onto the jack stands.
Never work under raised equipment unless additional
supports are used under the lifted equipment.
DANGER:
Always place the handle against the steel standard (bar)
Important!
1. Do not use extensions on the handle.
2. Always keep a firm hold on the handle.
11