Torin TRA8205B Manual De Propietario página 14

MAINTENANCE

Maintain your jack. It is recommended that the general condition of any jack be examined
before it is used. Keep your jack in good repair by adopting a program of conscientious repair
and maintenance. Have necessary repairs made by qualified service personnel.

Follow the maintenance instructions carefully to keep your equipment in good working condition.
Never perform any maintenance on the equipment while it is under a load.
a. All moving parts of the jack should be regularly cleaned.
b. Lubricate parts as required by the manufacturer's specifications. The type of lubricant should be
as specified by the manufacturer or a qualified person. Lubrication systems should be checked
to verify proper operation.
c. If additional maintenance is required, it should be completed in accordance with the instructions
of the manufacturer or qualified person.
Inspection
You should inspect the product for damage, wear, broken or missing parts (e.g.: pins) and that all
components function before each use. Follow lubrication and storage instructions for optimum
product performance. Check the climbing pins to make sure that they are not worn or damaged.
Check the steel standard (bar) to make sure that it is straight and that nothing is blocking the holes.
Do not use the jack unless it is in good, clean working condition and properly lubricated.
Binding
If the product binds while under a load, use equipment with equal or a larger load capacity to lower
the load safely to the ground. After un-binding; clean, lubricate and test that equipment is working
properly. Rusty components, dirt, or worn parts can be causes of binding Clean and lubricate the
equipment as indicated in the lubrication section. Test the equipment by lifting without a load. If the
binding continues, contact Customer Service.
IF YOUR JACK BINDS
As your jack becomes older, the climbing pins may start binding in the holes of the steel standard
(bar). This will prevent the jack from operating properly and safely. Rusty climbing pins, dirt, or a
worn bar can cause binding. Clean and lubricate the lifting mechanism. Test the jack by jacking it up
without a load. If the binding continues, refer to the after sale parts and service. If your jack binds
while under a load, use a jack with equal or larger load capacity to lower the load safely to the
ground. Repeat the steps in this paragraph to the binding jack.
Cleaning
If the moving parts of the equipment are obstructed, use cleaning solvent or another good
degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.
14