Husky 48WC01BP-THD Manual Del Operador página 11

MOUNTING UNIT
OPTION 1
HUSKY® TRACKWALL INSTALLATION
Process:
• Option (1) is for hanging the cabinet on Husky®
Trackwall only. If hanging cabinet directly on wall go to
Option (2).
• With assistance hook Hanger Bracket over Trackwall
and slide down into place.
Hook over trackwall and
slide down into place.
Figure 16
Note: Unit cannot be placed over a joiner section of
Trackwall. Unit must be hung either left or right of
joiner and then slid over the joiner.
Step 16 Option 1 Result
OPTION 2
WALL/STUD INSTALLATION
Warning
Wall Cabinet MUST be attached to two studs in a wood
frame wall. Use appropriate hardware per your local
building codes. Use two or more people to move and
assemble cabinet. Cabinet must be mounted level.
Failure to do so may cause personal injury or product
damage.
Items Needed:
Drill
1/8in Drill Bit
Mounting hardware as defined by your local building code.
Process:
• Option (2) is for hanging cabinet directly on wall. Holes
are provided for studs on 16-in and 24-in centers.
Assembly shown for installation on 16-in centers.
• Align Wall Cabinet with studs.
• Mark and drill (2) 1/8-in pilot holes.
Note: Use outside holes for mounting to studs on 24-in
centers. Use inside set of holes for mounting to studs
on 16-in centers. (The ones drilled out from step 9,
option 2.)
• Attach Wall Cabinet to studs using appropriate
hardware as defined by your local building code.
16-in Centers
24-in Centers
Figure 16.5
11