Faucet Installation - Price Pfister CONTEMPRA 49 Serie Manual Del Usuario

Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
NOTE: If installation surface depth is thicker than 1
number 971-026.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old f aucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape • Plumber's putty
• Phillips head screwdriver • Pliers
• Flashlight • Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
B
F
D
L
E
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout B Handles (2x)
D Valve Bodies (2x) E Pop-Up Assembly
G Bag [Seal Ring, Valve Adapters] (2x)
J Bag [Nuts (2x), Square Washer (2x)]
K Bag [Seal Ring, Metal Washer, Long Nut]
If any of these items are missing, please contact Price Pfi ster Consumer Service at
1-800-Pfaucet (1-800-732-8238).
1
/ ", order spare part
2
• Slotted screwdriver
• Adjustable wrench
B
A
C
G
G
D
K
H
J
C Spout Base
F Pop-Up Rod
H Hose
L Bag [Ball Rod, Strap]
ENGLISH

FAUCET INSTALLATION

5
5A
5B
5 SPOUT INSTALLATION
Insert Lift Rod (5A) into hole at the back of Spout (5B). Place Plastic Seal Ring (5C)
against the bottom of Spout Body (5D). With Spout (5E) facing forward, carefully
install the Lift Rod (5A), Shank (5F) and receiving Tube (5G) through the center hole
of sink (5H).
6
6A
6 SECURING FAUCET
From underneath sink, secure the faucet by placing the Metal Washer (6A)
and the Long Nut (6B) ( 7 / 16 hex.) onto the Mounting Post (6C). Make sure
that the bumps on the Metal Washer (6A) are facing up. Tighten using a fl athead
screwdriver or an adjustable wrench until the faucet is fi rmly connected to the sink.
Do not over tighten!
2
5E
5D
5C
5F
5G
5H
6A
6C
6B
6B