Hammerhead HLCL04 Manual Del Usuario página 10

OPERATION
4. FOR LASER LINE PROJECTION ON WALLS
There is a mounting pin inserted in each side of the laser line level body: the thin
pins can be pressed into any soft wood or wall-board surface to secure the tool.
Mounting holes on the laser line level
a. Pull the two mounting pins out from their holes in the level.
b. Determine location for laser line on the wall and mark it.
c. Align the mounting pins with the holes on the laser line level body.
d. Press the pins fully into soft wood or wall board.
Mounting holes on the adjustable wall-mount base
a. Pull the two mounting pins out from their storage holes in the adjustable
wall-mount base.
b. Determine location for laser line on the wall and mark it.
c. Align the mounting pins with the holes on the adjustable wall-mount base.
d. Press the pins fully into soft wood or wall board and ensure that the base is
fixed securely before attaching the laser line level body onto base.
When not in use, keep the mounting pins stored in their storages holes.
5. FOR LASER LINE PROJECTION ON FLOORS
a. Determine the location.
b. Set the laser line level on the floor.
c. Turn the laser line level ON.
d. Turn the laser line level body until the indicator pointer is at the desired
angle as shown on the 360° rotating protractor scale.
e. Align flooring material with the laser line on the floor surface.
10 LASER LINE LEVEL