Important - Evenflo Top-of-Stair PLUS Instrucciones

NEVER use with a child or pet able to climb over, dislodge, or open the gate.
NEVER leave child unattended.
with children from 6 months through 24 months.
in openings between 30" (76 cm) and 48" (122 cm) wide.
allow space between bottom of gate and floor to exceed 3" (7.62 cm).
with locking/latching mechanism securely engaged to help prevent dislodging.
stud to help prevent damage.
attempt to step over gate.
using gate if any parts are missing or damaged to help ensure proper gate function.
NOT necessarily prevent all accidents.
head or body
Top Rail
Slats
Bottom Rail
(8) Long Hinge Screws
(1) Paper Mounting Template
(2) Hinge Plates
(2) Latch Housings
(1) Swing Stop
(2) #10 x 1/2" Screws
An electric drill with 1/8" drill bit, Phillips screwdriver, pencil, and adhesive tape. Use a handheld Phillips screwdriver when
installing screws. Note: If you are missing parts, visit us at www.evenflo.com or call ParentLink at 1-800-233-5921.
Canada:
WARNING
Latch Mechanism
Hinge
Brackets
Gate Panels
USA: 1-800-233-5921, 8 AM – 5 PM E.T.
México: 01-800-706-12-00

IMPORTANT:

1. Inspect both gate panels to be certain that the slats are securely attached to the rails. If any slats are loose or damaged, call
Evenflo Parentlink at 1-800-233-5921.
2. You can use this gate at the top or bottom of stairs
The gate is mounted into a solid wood structure, e.g. wooden doorway jamb, solid wood banister post, or wall stud behind
drywall.
WARNING
A
Latch
Housings
B
A
D
C
if:
WARNING
IMPORTANT:
attempt to mount the brackets into uneven molding or wall base board trim, as the
gate will not function properly.
mount the gate less than 2" (5 cm) or more than 3" (7.62 cm) above the floor.
Make sure the mounting template is in a straight
vertical position.
1. Using adhesive tape, attach the mounting template on the solid wood surface that you
have chosen for the hinged side of the gate.
2. Drill four 1/8" (3 mm) diameter starter holes into the mounting surface at the crosshatch
marks on the template.
3. Remove the template from the wall.
4. Drill each hole to a depth of 2" (5 cm).
5. Using hinge screws, screw the two hinge brackets
the tabbed edge down. Tighten the screws until the hinge brackets are securely
fastened to the mounting surface.
6. Slide the hinge side of the gate down through both hinges
B
seated.
7. Squeeze the latch mechanism and slide the upper latch housing
C
mechanism until it snaps into place.
1
A into the mounting surface with
until it is securely
A
over the latch
D