Layout And Items Supplied; Proper Use - EINHELL TH-MA 1300 Manual De Instrucciones Original

tion. We recommend that you fit a residual-
current protection device with a maximum
nominal tripping current of 30 mA. Seek the
advice of your electrician.
•
Make sure that no moving tool parts come
into contact with the voltage.
•
Always guide the power cable away from the
back of the tool.
•
Protect the diamond cutting wheels from im-
pacts, jolts and grease.
•
The device may only be used for dry cutting
in masonry walls.
•
Important! The diamond cutting wheels be-
come very hot during use; never touch them
before they have cooled down again.
•
Keep your hands clear of the rotating dia-
mond cutting wheels at all times.
•
If the diamond cutting wheels are blocked the
device will respond by jolting. Switch off the
device immediately if this should happen.
•
If the device comes into contact with live
cables, metal parts on or in the device may
become live and cause an electric shock. It
is therefore important that you only ever hold
the device on the insulated handles.
•
Before starting to cut grooves in load-bearing
walls you should always seek the advice of
the responsible statics engineer, architect or
site engineer.
•
Use a cable/pipe detector to check for conce-
aled electric cables and gas and water pipes
in the wall.
•
Important! For health safety reasons it is
imperative that you use a vacuum extractor
unit. The extractor socket is suitable for use
on vacuum extractor units (vacuum cleaners).
The extractor unit must be suitable for the ext-
raction of fine dust.
Do not lose these safety regulations.

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Handle
2. Spindle lock
3. Guard hood
4. Operating switch
5. Safety lock-off
6. Locking screw for depth stop
7. Depth stop
8. Additional handle
9 . Vacuum extractor unit adapter
10. Guide roller
Anl_SA_TH_MA_1300_SPK8.indb 21 Anl_SA_TH_MA_1300_SPK8.indb 21
GB
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions

3. Proper use

This equipment is designed for cutting channels
for pipes and cables in masonry walls.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
- 21 -
09.12.14 07:47 09.12.14 07:47