PLANT!T GoGro Essential Manual De Instrucciones página 8

Expanding your GoGro
Essential System
Your setup can be expanded up to a maximum of 8 plants.
The GoGro Expansion 2 Plant kit allows you to expand your set up
2 plants at a time, with ease. The kit contains all the required parts,
including extra 4mm Tube.
We suggest you plant up the pots and allow the plants to
establish before adding them to an already growing system.
Adding modules:
1. Close the On/Off Tap and open the Flush tap; a small volume of
water may run through, run to waste or catch in a jug.
2. Detach the Flush Tap, it is advised to also cut off the last 1cm of
4mm Tube to ensure a tight fit to the new barb tee.
3. Add Barb Tees and fit extra lengths of 4mm Tube for each module
as required.
4. End the main Feedline by reinstalling the Flush Tap.
5. Set-up and connect the GoGro Expansion Trays and Valves,
as per the earlier instruction on page 5.
6. If the plants within your system are established and growing,
don't forget to shut the Flush Tap and open the On/Off Tap
7. If your plants are not yet established, follow the watering
instructions on page 7 before opening the On/Off Tap.
GoGro and PLANT!T are HydroGarden brands | 2 Progress Way, Binley, Coventry, CV3 2NT, UK | www.hydrogarden.com
HydroGarden have taken all reasonable care in preparation of this information but make no guarantees as to the
accuracy or completeness of the information and cannot be held responsible for any resultant effects of using
this information on any person or thing including plants or equipment. We reserve the right to change product
specifications and prices without prior notification. We accept no responsibility for any such changes or errors and
omissions. Use of these instructions is solely at the customers discretion and risk.
UK Patent (GB2498542B), US Patent (US 9,453,58B) and pending European application (EP2805090A)
Expansion
Expansion
Reservoir