System Operation; Pairing Instructions - Southwire Triggers TSS-01 Instrucciones De Operación

Operation

Pairing Instructions

ALL UNITS COME PAIRED FROM FACTORY, DO NOT PRESS PAIR BUTTON
UNDER NORMAL OPERATION
1. Turn on Master Unit.
2. Turn on all other units to be paired.
3. Hold down "PAIR" button on Master Unit until "LINKED" light
begins flashing.
4. Hold "PAIR" button on unit to be paired to Master until the
"LINKED" light starts flashing.
5. Once unit is paired one LED on the Amperage Draw Indicator will
light up for each paired unit, the "LINKED" light on the unit being
paired will turn off and the unit will cycle through all of the LED's.
6. Repeat step 4 for each additional unit to be paired. Each additional
unit paired will have a corresponding LED light up on the Amperage
Draw Indicator.
7. The number of units paired can be verified by counting the number
of LED's lit up on the Amperage Draw Indicator.
8. Once all desired units are paired press the "PAIR" button on the
Master Unit to complete the pairing process
NOTE:
If adding to or removing units from the system it is suggested,
but not necessary, that all units be re-paired. To clear all paired units,
on Master pedal hold down the "PAIR UNIT" button while turning on
the pedal until blue LINKED light stops flashing. This will clear the list
of all previously paired units and put the pedal into pairing mode.
Once this has been done, start from step 4 of the pairing instructions.

System Operation

SET UP
1. Plug a 20 amp 120 Volt, 10 gauge extension cord into the extension
cord input (16) of the Master Unit. If using a 15 amp motor or less
you may plug in a 15 amp 120 Volt extension cord using a 20 amp
to 15 amp adaptor plug.
2. Plug Puller's electrical cord into Triggers input (17).
3. Lift up antenna (11).
11