Battery Charging And System Storage - Southwire Triggers TSS-01 Instrucciones De Operación

Operation cont.
AMPERAGE DRAW INDICATOR AND LOW VAC INDICATOR
The amperage Draw Indicator is scaled to read from 0 to 20 Amps. This is
not a safety feature and is to be used for reference only. The unit itself does
not provide any over amperage protection.
LOW VAC indicator light indicates when the line voltage has dropped
below the minimum recommended input voltage. This is not a safety fea-
ture and is to be used for reference only. The unit itself does not provide
any under voltage protection.

BATTERY CHARGING AND SYSTEM STORAGE

ALL BATTERY POWERED UNITS SHOULD BE FULLY CHARGE PRIOR
TO USE ON WIRE PULL
Both the Remote Unit and the Handheld Units contain Li-Ion battery
packs that require periodic freshening charges at least once every 6
months when not in use. Before storage, all battery-operated units in the
system should be charged to approximately 60 percent. Case provides
for quick and easy recharging. Plug in respective 9V cords to Handheld
units and place in case, Plug Remote foot switch into power strip. Plug
power strip into outlet and allow all components to charge in the case.
REMOTE PEDAL
1. Plug pedal into outlet. Battery meter will show approximate level of
charge. Once charging is complete, the battery meter will go solid.
HAND HELD UNIT
1. Plug supplied 9V power supply into Handheld Unit.
2. Ensure 9V power supply is plugged into supplied power strip.
3. "The "CHARGE" light will illuminate and the battery meter will flash the
approximate level of charge. Once charging is complete the battery
meter will go solid and the "CHARGE" light will turn off.
14