Southwire Triggers TSS-01 Instrucciones De Operación página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trigger`s system reboot
1. Turn off power to all Trigger's Units
2. Press and hold the blue PAIR button and the red Power button on
the Master Unit until blue LINKED light illuminates and turns off.
Release both buttons at the same time.
3. Push the POWER button on all units to be paired. Press and hold the
blue PAIR button on each individual unit to be paired until the blue
LINKED light starts to flash. Release the blue PAIR button.
4. Master Unit will illuminate one green LED light on Amperage Draw
Indicator light bar for each unit that is being paired.
5. Once you have three green LED lights on the Master Unit, Press and
release the blue PAIR button on the Master Unit.
6. Green LED lights on the Amperage Draw Indicator light bar will
disappear. Wait a couple of seconds for the three green LED lights to
re-illuminate.
7. Press the foot pedal on the Master Unit. The blue LINKED lights on
all Units will illuminate and system is ready for use.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido