decorflame MM645PT-46FBK Manual Del Usuario página 7

MAINTENANCE
warNiNG: DiScONNEct pOwEr aND UNplUG tHE pOwEr cOrD BEFOrE attEMptiNG aNy
MaiNtENaNcE Or clEaNiNG tO rEDUcE tHE riSk OF FirE, ElEctric SHOck Or DaMaGE
tO pErSONS.
The bulbs in your unit can become extremely hot. Allow at least 10 minutes between
turning off the unit and removing the light bulbs to avoid the accidental burning of
the skin.
riSk OF FirE: DO NOt ExcEED tHE rEcOMMENDED BUlB wattaGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are 2
larger screws and 10 smaller screws.
Step 2: You will find 1 x 40W type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into top left corner hole and bottom
right corner holes, as shown in the diagram. Secure the 10 smaller screws into
the remaining holes. Make sure the screws are in the correct holes and have
been tightened.
Step 5: Plug in the unit.
Larger screw
REPAIR SET
Larger screw
Bulb
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if necessary.
REPAIRS
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the
following methods.
Tools required: Electric drill, drill bit 10 mm (3/4 in) or 2 mm (1/16 in), pencil, hammer,
Phillips screwdriver, safety goggles and gloves (if necessary).
warNiNG: wEar GOGGlES BEFOrE yOU Start DrilliNG.
OptiON 1:
Use the spare nuts, screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes, as shown in
Fig. A.
2. Drill the holes with diameter 3/4 in (10 mm) and depth 3/4 in (10mm) on the mantel.
Each plastic connector needs 3 holes. See Fig. B.
Fig. B
3. Gently install the nuts into the drilled-holes with hammer, as shown in Fig. C.
7
Fig. A
Fig. C