Stanley FatMax FME140 Manual De Instrucciones página 4

WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the state of California to
cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
• The label on your tool may include the following symbols. The symbols and their
Symbols
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
Volts
120V
240V
Ampere Rating
More
Than
0 -
6 -
10 -
12 -
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
Always expect the stall. Grip the drill firmly with both hands to control the twisting action
WARNING:
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
Minimum Gage for Cord Sets
Total Length of Cord in Feet
0-25 26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more American Wire Gage
Than
6 18
10 18
12 16
16 14
Drill may stall (if overloaded or improperly used) causing a twist.
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm ........revolutions or reciprocation
51-100
101-200
16 16
16 14
16 14
12 Not Recommended
4
per minute
101-150
201-300
14
12
12