Electrical Connections - Fagor AD658XC1 Manual De Utilización

99638191_ML.qxp 19/01/2006
2 / INSTALLING YOUR APPLIANCE
EN
• • ELECTRICAL CONNECTIONS
During installation and maintenance opera-
tions, the appliance must be unplugged from
the electrical grid; fuses must be cut off or
removed.
The electrical connections are made before
the appliance is installed in its housing.
Ensure that:
- the electrical installation has sufficient volt-
age,
- the electrical wires are in good condition,
- the diameter of the wires complies with the
installation requirements.
Warning
This appliance is delivered with a
H 05 VVF power cord that has three-
0.75 mm 2 conductors (neutral, phase and
ground). It must be connected to the main
power supply (which should be a 220-240 V
single phase current) via a CEI 60083 stan-
dardised socket that should remain accessi-
ble after installation, in keeping with instal-
lation guidelines.
We cannot be held responsible for any acci-
dent resulting from an inexistent, defective
or incorrect ground lead. The fuse for your
installation must be 10 or 16A. If the power
cable is damaged, call the after-sales serv-
ice department in order to avoid danger.
Warning
If the electrical installation at your
residence requires any changes in order to
hook up your appliance, call upon a profes-
sional electrician.
Warning
If the hood displays any malfunctions,
unplug the appliance or remove the fuse
corresponding to the electrical socket
where your appliance is plugged in.
11:16 Page 56
56