Publicidad
Idiomas disponibles
Idiomas disponibles
The heat gun is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use by a person responsible for
their safety.
Children should be supervised to ensure that they do not
play with the heat gun.
If the supply cord is damaged, it must be replaced by
the manufacturer, a service agent or similarly qualified
person in order to avoid a hazard.
STRIPPING OF PAINT, VARNISH
Various paint finishes react to heat differently as far as
time needed for stripping and how they appear when
heated.
Latex may simply soften. Oil base paints will bubble or
blister and may start to lift off the wood. Pretesting is
recommended, so you do not scorch the wood beneath
by use of excess heat.
Choose a suitable scraper, turn on heat gun and allow it
to reach full heating power. Point the airflow at the work
to be done, keeping the nozzle about 3-4" away from
its surface. Allow the paint to thoroughly soften. Move
the gun slightly from side to side. Do not overheat paint.
Always keep scraper clean for best result.
CAUTION: Lead paint fumes are harmful.
Always provide adequate ventilation while
working indoors.
REMOVAL OF ADHESIVE FLOOR TILE
Under high heat, floor tile adhesives will soften. Point heat
gun to small area and lift tile with a scraper, moving the
heat gun ahead as tile lifts.
OPERATING ISSUE
Gun will not turn on.
Gun blows only cool air.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 6
SAFETY CONTINUED
OTHER JOBS
REMOVING:
LOOSENING:
THAWING:
DRYING:
SOFTENING:
SHRINKING:
WAXING:
IMPORTANT
• Keep the air intake and outlet openings clean and
free of dirt and debris.
• Do not use gasoline, lacquer, turpentine or similar
substances to clean the tool. Use only a dampened
cloth. Do not immerse any part of the heat gun into
any liquid or let any liquid gas inside the gun.
TROUBLESHOOTING
RECOMMENDATIONS
If the gun has recently been used for an extended
period of time, allow the gun to cool for 20-30 minutes
and try again. The internal thermostat may be keeping
the gun from turning on.
Adjust the dial on the back of the unit.
1-800-295-5510
uline.com
Self-Adhesive stickers and trim.
Rusted, over tightened nuts and metal
screws.
Frozen steel pipes, door locks,
padlocks, etc.
WARNING! Do NOT attempt to thaw PLASTIC.
Paint and varnishes, as well as wet,
damaged timber prior to filling with
compound and refinishing.
Old putty before removal and
replacement.
PVC or polyolefin shrink-wrap sheeting for
packaging protection.
Polyvinyl wire joint.
Waxing or dewaxing skis.
NOTE: This tool is designed with a built-in stand
so it can be put on any flat surface in an upright
(vertical) position to free both hands to easily
shape old PVC pipes and similar materials.
Always remember to avoid contact of hands or
face with stream of hot air when using the gun in
any position.
1019 IH-915
Publicidad
