Broan Elite 63000 Serie Manual De Instrucciones página 7

MOUNT HOOD TO SUPPORT
FRAME
1. Before mount hood to support frame remove
the electrical box.
2. Mount hood to support frame.
3. Insert four (4) bolts through the top of the
hood - from the inside.
4. Use four (4) nuts and four (4) washers
(Ø6,4mm) to secure hood to support frame
as shown.
5. Replace electrical box.
USE (4) NUTS AND (4) WASHERS
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box.
2. Secure the conduit to the wiring box
through a conduit connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
WASHER
NUT
(D.6.4MM)
BOLT
- 7 -
ELECTRICAL BOX
WIRING BOX
COVER