Slime M50048-2 Guia De Inicio Rapido página 2

FLAT TIRE REPAIR INSTRUCTIONS:
NOTE: Seals punctures up to 1/4" (6mm) in tread area. Correct tire pressure can be found in
your vehicle's owner's manual or driver side doorjamb.
1
2
3
4
Drive one mile to dispense sealant throughout the tire, allowing it to seek out and seal the
puncture. Recheck tire pressure to verify that the puncture has been sealed.
Check your tire warranty prior to installation of this product.
At your earliest opportunity take your vehicle to a tire repair facility for a permanent
professional repair. Inform tire repair specialist that Slime is in the tire.
1. Attach (clear) sealant hose to tire valve stem.
NOTE: Lay Safety Spair flat on the ground facing
upward.
2. Plug inflator into accessory power outlet. Do not run
vehicle while inflator is operating. You may need to
be in "accessory" or "on" position. Please make sure
emergency brake is set and car is in park.
3. Attach (black) air hose to sealant cartridge nozzle,
located at the top of the sealant cartridge.
4. Push green button to turn system on. Wait 6 minutes
(in temperatures below 32˚F wait 12 minutes). Some
sealant may remain in the hose. Turn system off and
check tire pressure. If additional air is needed follow
"air only" instructions. Once correct tire pressure has
been achieved disconnect the system.