Electrolux AEG M 2500 Instrucciones Para El Uso página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
822_949_158 M2500.book Seite 11 Montag, 18. Februar 2008 12:13 00
blender apart and re-assembling. It
may cause injury if handled incor-
rectly
• Do not leave hard objects (for example
spoons) in the blade assembly while
running, and do not grasp the appli-
ance with the hand inside the blender
tank. This may cause injury!
• The manufactuer will not be responsi-
ble for any damage due to inappropri-
ate use or incorrect operation.
This appliance conforms with the fol-
;
lowing EC Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 89/336/EEC with
amendments 92/31/EEC and
93/68/EEC
Technical Data
Mains voltage: 230/240 V
Power consumption: 500 W
Possible applications
The blender can be used for mixing a
wide variety of drinks, crushing ice,
reducing fruit and vegetables, whip-
ping cream, etc.
Cord storage drawer (Figure 2)
The appliance is fitted with a storage
drawer at the bottom. If the connec-
tion cord to the power outlet is too
long, it can be fed back into the drawer
until it is the required length.
Disassembling the Apliance
0 Take the plug out of the socket.
0 Turn the tank clockwise and remove
(Figure 3).
0 Turn the blade assembly counterclock-
wise using the filler cup (Figure1/C) as
tool and remove (Figure 4). The grooves
of the filler cup fit the ribs of the blade
assembly.
Caution! the blade assembly is very
1
sharp. It can cause injury if handled
incorrectly.
Caution! Do not use force when taking
the blade assembly out of the blender,
as this might cause damage. If neces-
sary, tilt it slightly when removing.
Assembling the blender
0 Place the rubber seal on the blade
assembly (Figure 5).
0 Insert the blade assembly holding the
blender downwards. Turn it clockwise
to fasten it using the filler cup as tool
(Figure 6). Caution! Handle carefully!
0 Place the tank on the motor casing and
turn it counterclockwise till it reaches
the end stop. The two arrows should be
aligned (Figure 7).
0 Set the lid on the tank and turn it till
the nose is located directly over the
handle (Figure 8).
3
The dual safety device only allows the
blender to be operated if the tank and
lid are correctly positioned (Figures 7
and 8). See paragraph on the "Dual
Safety System".
0 Insert the filler cup (Figure 1/C), and
lock it in.
Operating the Blender
3
Place the blender on a level, dry sur-
face.
0 Open the lid (Figure 1/D) and put all
the required ingredients in the tank.
Important! Do not exceed the maxi-
mum capacity of 1.5 litres.
You can add other ingredients through
3
the filler hole while the blender is run-
ning. You can use the filler cup in the
lid to do this (Figure 1/C). Close the
filler hole immediately after, to avoid
splashing.
0 Start the blender by turning the selec-
tor (Figure 1/J) to the right, or by
pressing the Pulse Button (Figure 1/H).
We recommend starting with blender
3
Speed 1, then progressing to Speed 2.
g
11

Publicidad

Tabla de contenido
loading

Tabla de contenido