Cequent Performance Products 24946 Instrucciones De Instalación página 4

1. Mark centerline of fascia with marker or tape.
3. Open trunk: Open trunk to remove
the hex screw (2) from under the rear
hatch securing the bumper fascia.
Repeat for each side.
©2016 Cequent™ Performance Products, Inc. -
2. Remove plastic rivets and screws: Remove plastic rivets from supports on bottom of bumper
fascia. Rivets are released by first pulling out center post of rivet approx 1/4". Rivet can then be
pushed out by hand. Remove the Philip screw ( approx. 3 each side).
4. Bumper fascia removal; Loosen the tail lights bolts for additional clearance for fascia removal. Gently pull up
from the rear wheel well trim panel each side, unclipping the tabs inside. Work up to taillights and continue to
gently remove along the bottom of the tail lights. Using a small screwdriver lift cleats between the fascia and tail
lights if needed. Continue to remove along inside bottom to the trunk, if needed, use a small flat screw driver to
release the cleats at the top of the fascia while carefully pulling the fascia away from the vehicle. If present
disconnect any wiring harness at the fascia, and put the fascia cover aside.
Printed in Mexico
Sheet 4 of 18 24946NP 6-17-16 Rev. A