Ridgid Kollmann K-2000 Manual Del Operador página 7

FOR/OFF/REV
Switch
Motor Table
Ratchet Knob
Drive Motor
Figure 3 – K-2000 Machine with Cable Guide Hose and Clutch Handle in Clutch Casting
WARNING
Never change power drive chain from one sprocket
to the other with engine/generator running.
Figure 2 – Power Drive Chain on Large Sprocket
6. Pull ratchet knob again to drop motor table into po-
sition, making sure chain slack is taken up. Put
ratchet knob in LOCK POSITION.
7. Put machine guard back in place.
8. Screw clutch handle (Figure 3) into clutch casting.
9. Attach cable guide hose (Figure 3).
NOTE! If inlet is not a manhole, disregard steps 10
through 12.
10. Set telescoping manhole guide pipe (Figure 4) for
depth of manhole. Place turnbuckle into manhole
opening.
K-2000 Municipal Sewer Cleaning Machine
Clutch Handle
Clutch Casting
Guard
Latch (2)
Ridge Tool Company • Elyria, Ohio • U.S.A.
Cable Counter
Guide Hose
Engine/Generator
Gear Motor Plug
Rear Wheel
Front Wheel (2)
11. Insert first cable through manhole guide pipe and at-
tach tool.
12. Put guide pipe into manhole and secure with "J"
bolt to turnbuckle of guide pipe.
13. Attach next length of cable and feed from front
through machine and through rear guide hose.
Turnbuckle
No. A-17 Telescoping
Manhole Guide Pipe
Manhole
Figure 4 – Telescoping Manhole Guide Pipe
5