Ingeteam INGECON EMS Manager Manual De Instalacion Y Uso página 31

Unit description
Ethernet
The Ethernet connection via the RJ45 connector is used for internet connections and to connect existing inverters
in the installation to the device.
RS-485 communications may be used if there are several units in the same phase of the installation.
A switch is required to deal with all connections (not supplied with the INGECON EMS Manager).
For correct internet connections, the UDP80 port on the router connected to the INGECON EMS
Manager must be open.
See the communication´s manual via Ethernet to obtain more information about the communication
of the system´s equipment.
USB
Via the USB we can update the INGECON EMS Manager firmware. Contact with sat@ingeteam.com for more
information.
Potential-free contacts
The INGECON EMS Manager has two potential free outputs.
A1
Description of the potential-free contacts in the INGECON EMS Manager
Their function will depend on the devices existing in the installation.
• Control of single-phase loads for their connection and disconnection.
• Storage systems for decoupling from the grid to become an off-grid network.
• Other functions.
AAX2022IQM01_ - Installation and Operation Manual
1 0
B1 A0 B0
Ingeteam
DE
EN
ES
FR
IT
PT
31