Personal Protective Equipment (Ppe) - Ingeteam INGECON EMS Manager Manual De Instalacion Y Uso

Ingeteam
Carry out all control and handling without voltage.
As a minimum security measure in this operation, you should always follow the so-called 5 golden
rules:
1. Disconnect.
2. Prevent any possible feedback.
3. Check there is no voltage.
4. Ground and short circuit.
5. Protect from live elements, if any, and put up safety signs around the work zone.
Until these five steps are completed, the work area cannot be considered voltage-free and any work
performed will be considered to be work on live equipment.
Potential hazards for people
Bear in mind the following warnings concerning personal safety.
The casing must not be opened.
Potential hazards for the equipment
Bear in mind the following warnings concerning protection of the equipment.
CAUTION: connections.
After all duly authorised handling, check that the equipment is ready to start operation. Only after
this can you connect it following the instructions in the manual.
Do not touch boards or electronic components. The more sensitive components can be damaged or
destroyed by static electricity.
Do not disconnect or connect any of the terminals while the unit is operating.

3.2. Personal Protective Equipment (PPE)

When working on the unit, use the following safety equipment recommended by Ingeteam as a minimum.
Name
Safety footwear
Helmet with face shield
Working clothes
Dielectric gloves
Tools and / or equipment used in live work must have at least Category III-1000 Volts insulation.
Should the country's regulations demand another kind of personal protection, the equipment recommended by
Ingeteam should be appropriately supplemented.
34
In compliance with standard UNE-EN-ISO 20345:2012
In compliance with Standard UNE-EN 166:2002, wherever there are directly
accessible live parts.
Close-fitting, non-flammable, 100% cotton
In compliance with standard EN 60903:2005
AAX2022IQM01_ - Installation and Operation Manual
Explanation
Safety