Publicidad
Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (I) and lay it over your unit.
Make equal margins along all four edges of the BACK (I).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (H).
With your hammer, gently tap four TACK GLIDES (12E)
å
into the bottom edges of the ENDS (A2 and B2).
www.sauder.com/services
I
A2
414436
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(49 used in this step)
These holes must line
up over the SHELF (H).
1N
B2
12E
Page 13
Publicidad
