Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1)
Turn off the power to the computer (PC) and remove the power cord from the
AC outlet.
2)
Remove the cover or the front panel from the PC.
3)
Remove the blank panel installed on the front of the 5.25" slot.
4)
Insert the drive into the slot.
5)
When affixing is required, please refer to the instruction manual that came
with your PC.
Please use screws with a length of 5 mm (3/16") or less for mounting. Using
longer screws may damage the drive.
When the mounting screws are loose, the vibrations from disc rotation may
generate a ripping noise. To prevent this noise, securely tighten the screws
When slide rails are required, please contact your place of purchase or the
computer manufacturer.
Cable Connections
1)
Turn off the power to the computer (PC).
2)
Insert the cable into the PC, paying close attention to the cable connector's
shape and polarity
3)
Connect the Serial ATA interface cable to the PC again paying close attention
to the connector shape and polarity.
Power for the drive is drawn from the PC. Do not use any other power supply than what
is supplied through the PC.
8
En
Publicidad
Tabla de contenido
