Vacuuming Dry Materials; Vacuuming Liquids; Important - RIDGID WD12701 Manual Del Usuario

SP6765-3 12 GALLON ES
Operation (continued)
To reduce the risk of electric shock, this
Vac has a polarized plug (one blade is
wider than the other except 230 volt
models). This plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols:
= OFF
Familiarize yourself with the accessories
included with the Vac. Each accessory may
be used in various ways for vacuuming
and blowing debris. Here is a list of the
accessories and their uses.
Utility Nozzle - General purpose nozzle for
most vacuuming applications.
Car Nozzle - Dry pickup nozzle for car
interiors and most upholstery cleaning.
Wet Nozzle - Used for wet pickup on
smooth surfaces to pick up liquid and dry
the surface in one stroke.
Extension Wands - These wands can be
connected together and provides
additional length for more reach.
Dual-Flex™ Locking Hose - Provides
transfer of vacuum or blowing capability
to work site. Provides the means of
attaching extension wands and nozzles.
9/23/12 8:00 PM Page 8

Vacuuming Dry Materials

1. The filter must always be in correct
2. Your using your Vac to pick up very
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up material when the filter is wet, the filter
will clog quickly and be very difficult to
clean.
= ON

Vacuuming Liquids

1. When picking up small amounts of
2. When picking up large amounts of
3. When the liquid in the drum reaches a
4. After using the Vac to pick up liquids,
IMPORTANT: To reduce the risk of
damage to the Vac, do not run motor
with float in raised position.
8
position at all times to avoid leaks and
possible damage to Vac.
fine dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain
peak Vac performance.
liquid the filter may be left in place.
liquid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. You will know that the float
has risen because Vac airflow ceases
and the motor noise will become higher
in pitch, due to increased motor speed.
When this happens, turn off the Vac,
unplug the power cord, and empty the
drum.
the filter must be dried to avoid possible
mildew and damage to the filter.