Vacuuming Dry Materials; Vacuuming Liquids; Blowing Feature - RIDGID WD40700 Manual Del Usuario

SP6732-2 4 gallon ES 9/11/12
Operation (continued)

Vacuuming Dry Materials

1. The filter must always be in correct
position at all times to avoid leaks and
possible damage to Vac.
2. When using your Vac to pick up very
fine dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain
peak Vac performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.

Vacuuming Liquids

1. When picking up small amounts of
liquid the filter may be left in place.
2. When picking up large amounts of
liquid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
WARNING: Do not operate
!
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
3. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off airflow. You will know that the float
has risen because Vac airflow ceases
and the motor noise will become higher
in pitch, due to increased motor speed.
When this happens, turn off the Vac,
unplug the power cord, and empty the
drum.
4. After using the Vac to pick up liquids,
the filter must be dried to avoid
possible mildew and damage to the
filter.
12:51 PM Page 7
Emptying the Drum
1. To remove the lid to empty contents of
the dust drum, simply lift the two drum
latches on the side of the Vac and lift
the power head up and off the dust
drum and set to the side.
2. Lay the power head upside down on a
clean dry area while emptying the drum
or changing the filter.
3. Dump the drum contents into the proper
waste disposal container.

Blowing Feature

Your Wet/Dry Vac has the capability to be
used as a blower for yard work, patio
cleanup and workshop applications to
blow sawdust and other debris.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
! WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
!
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
!
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
7
Power
Head
Dust
Drum
Drum
Latch