Publicidad
Idiomas disponibles
Idiomas disponibles
®
Assembly for New York Power-In Feed
(continued)
3
. Locate junction box 6" inward from the cantilever
bracket on the underside of the frame. Align box
and pre-drill holes for #10 screws, (#22 drill bit).
4.
Attach the box with screws provided.
5.
Drill pilot holes for strain relief brackets. Attach the harness
strain relief bracket to the bottom side of the horizontal rail with
screw provided (5a). Insert harness into the bracket (5b) and
secure harness with nut and bolt ( 5c). Connect the modular
end of the harness to the first modular power block.
Attach electrician supplied harness strain relief bracket in
location shown. Follow steps 5a - 5c to secure electrician's
harness.
STRAIN RELIEF
BRACKET
CANTILEVER
6 "
Page 8 of 84
1061950001 Rev C
Publicidad
