Using The Appliance - Moulinex JU550D10 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
SAFETY SYSTEM
This appliance is fitted with a safety mechanism. To start the juice machine, the cover (C)
must be properly secured by the locking handle (G). Unlocking the handle will stop the juice
machine. At the end of a cycle, place the control knob (J) to 0 and wait until the filter (D) stops
completely before removing the cover (C).
BEFORE FIRST USE
• We recommend that you wash all the removable parts (A, B, C, D, E, M, N) in warm soapy water
(see paragraph "Cleaning"). Rinse and dry them carefully.
• Unpack the appliance and place it on a clean, dry stable flat work surface away from water
splashes.
• Ensure that all packaging has been removed before starting the appliance.

USING THE APPLIANCE

• Place the pulp collector (E) on the body of the appliance (see Fig. 2).
EN
• Place the filter (D) in the pulp collector (E). Ensure that the filter is properly clipped onto the
drive shaft (H) (see Fig. 3).
• Fit the cover (C) on top of the pulp collector (E) and turn to lock the lid (see Fig. 4).
• Push the locking handle (G) to the rear until it locks into place. You will hear an audible "click"
(see Fig. 5).
• Slide the pusher (A) into the feeding tube (B) aligning the groove on the pusher with the small
ridge in the feed tube (see Fig. 6).
• Place the juice jug (M) under the pouring spout in front of the appliance (see Fig. 7).
• Plug in the appliance.
• To start the appliance, use the control knob (J).
• Insert the fruits or vegetables through the feeding tube (B).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher (A). Do not use any other utensil. NEVER push with your fingers.
• When you have finished, stop the appliance by turning the control knob (J) to 0 and wait until
the filter (D) stops completely.
• When the pulp collector (E) is full, or the juice flow slows down, empty the pulp collector and
clean the sieve and the cover.
• Remove the "pulp collector + filter" assembly by pulling vertically using both hands (see
Fig. 9 and 10).
62

Publicidad

Tabla de contenido
loading

Tabla de contenido