Stobag SRCR 100 L Instrucciones Y Advertencias Para El Instalador página 19

4) Programming SRCU 01O / 03O
When the memory contains no transmitters the first one can be memorized in mode II as follows:
Table "A4" Memorizing the first transmitter in mode II
1. As soon as the control unit is powered, 2 long beeps will sound
2. Press the transmitter key to be memorised within 5 seconds, and hold it down until you hear
all 3 beeps, then release.
3. Within 3 seconds press the same key of the transmitter as many times as the number corresponding
to the desired command: 1 = "ON/OFF" 2 = "MAN PRESENT" 3 = "TIMER1" 4 = "TIMER2"
4. After approximately 3 seconds, the user will hear a certain number of beeps. These beeps
correspond to the command selected.
5. Press the same key again within 2 seconds to confirm programming. Release this key when
you hear the first of the 3 beeps.
N.B.: If the memorization procedure is successful 3 long beeps will sound. If, at point 4, the user does not hear the same number of
beeps as the command required, wait for a few seconds to exit the procedure, without confirming the memorisation.
When one or more transmitters have already been memorised, others may be enabled in Mode II as follows:
Table "A5" Memorizing other transmitters in Mode II
1. Press and hold down the new key to be memorized until you hear a beep (after about 5
seconds) then release it
2. Within 5 seconds press and hold down the key of a previously memorized (old) transmitter
approx. 5 seconds until you hear 2 short beeps then release it.
3. Within 5 seconds press the same key of the (old) transmitter as many times as the number corresponding
to the desired command: 1 = "ON/OFF" 2 = "MAN PRESENT" 3 = "TIMER1" 4 = "TIMER2" Old
4. After approximately 3 seconds, the user will hear a certain number of beeps. These beeps
correspond to the command selected
5. Press the new transmitter key to be memorised again within 2 seconds to confirm programming.
Release this key when you hear the first of the 3 beeps.
N.B.: If the memorization procedure is successful 3 long beeps will sound.6 beeps will sound when the memory is full (30 transmitters),
telling you the transmitter cannot be memorised.
A new transmitter can easily be memorised, keeping the same features as the old transmitter, by following the procedure detailed in Table
"A6". Any new transmitters which are memorised in this manner will take on the same characteristics as the old one. If the old one was
memorised in Mode I, the new one will also operate in Mode I. If, on the other hand, the old one was memorised in Mode II, the key of the
new transmitter will also be associated to the same command as the old one.
Table "A6" Memorizing other transmitters
1. Hold down the key of the new transmitter you wish to memorise for at least 3 seconds,
then release
2. Press the key of the (old) transmitter you wish to memorise for at least 3 seconds, then release.
3. Press the key of the new transmitter again for at least another 3 seconds, then release.
4. Press the key of the old transmitter again until 3 beeps sound to confirm the new transmitter
has been memorised.
N.B.: 6 beeps will sound when the memory is full (30 transmitters), telling you the transmitter cannot be memorised.
www.stobag.com
Example
5s
1-4 3s
1-4 3s
2s
Example
New 5s
Old 5s
1-4 3s
1-4 3s
New 2s
Example
New 3s
Old 3s
Old 3s
19
GB