Replacing The Fuse - Steren MUL-105 Manual De Instrucciones

REPLACING THE FUSE

Caution:
Before removing the cover from your multimeter, make sure the
testing points are disconnected to avoid the risk of electrical
shock.
1.- To replace the fuse (0,5A / 250V and 10A / 250V
respectively), remove the cover from the multimeter removing
the three screws on the back of the multimeter.
2.- Replace the fuse paying attention to polarity.
3.- Replace the cover on your multimeter.
The fuse rarely needs to be replaced and when it does, it is
usually due to an error in operation.
If "BAT" appears on your LCD screen, the battery needs to be
replaced.
To replace the battery and the fuse (15 A / 250 V), remove the
cover from the multimeter removing the three screws on the back
of the multimeter. Replace the fuse and/or battery and replace
the cover on your multimeter.
The characteristics for this multimeter are subject to change The characteristics for this multimeter are subject to change
without notice. without notice.
ENGLISH-6