Seat Pad; 12 'C' Shaped Clips - bloom fresco Guia Del Usuario

eng
WARNINGS:
• Not recommended for children who can sit
up by themselves (6 months approximately).
• Never leave the child unattended when the
baby chair is in cradle mode.
• The child should be secured in the baby
chair at all times by the 5-point safety
harness in the reclining position.
• It is dangerous to put this cradle on an
elevated surface.
• Keep the product away from open fire,
heaters and other sources of strong heat.
• Do not use the product unless all components
are correctly fitted and adjusted.
• Make sure harness is correctly fitted before
use.
b - b Seat Pad & Safety Harness Assembly
– (#05 seat pad, #06 safety harness) Put
shoulder straps through the seat pad slits at
the lower height setting.
– Put waist straps through the seat pad slits.
– Place seat pad onto the seat unit; secure onto
velcro.
– (#10 seat unit Behind the seat pad, slide the
buckle on the end of the shoulder straps into
the buckle slots located on the inner face of
seat unit. Check the straps are secured by
pulling on the straps.
– (#09 storage compartment) Behind the seat
pad, pull open storage compartment door
located on the inner face of seat unit. Slide
the buckle on the end of the waist straps into
the buckle slots on either side of the storage
4
compartment. Check the straps are secured
by pulling on the straps.
– (#12 'C' shaped clips, #13 crotch cover) From
storage compartment, take out the two 'C'
shaped clips and the crotch strap cover.
Close the compartment door.
– Snap the 'C' shaped clips on either side of the
seat unit; you will hear an audible click.
– Place buckle on the end of the crotch strap
under the crotch strap cover, then slide the
crotch strap cover into the seat unit. (The
strap and buckle must not be twisted or
inverted. This will ensure correct locking of the
harness.)
– Adjust the length of the harness straps until it
fits firmly around your child.
WARNING:
Always use the safety harness.
To remove the seat pad & safety harness for
cleaning, follow the instructions given in the care
& maintenance section of this user guide.
b4 Using and Adjusting the Safety Harness
Locking the Safety Harness:
Lock the harness by pushing the tongues on
the ends of the waist straps, connected with the
ends of the shoulder straps, into the buckle on
the crotch strap.
The harness will automatically lock when the
tongues have been fully pushed in. You will hear
an audible click.