Getting Started - oneConcept Heat Spike Manual De Instrucciones

EN
20

GETTING STARTED

Location
The appliance should be placed with a minimum distance of 90 cm away from
flammable objects (e.g. curtains), walls or other structures!
Power cord
1. Use only an approved extension cord that is suitable for the appliance
rating!
2. Do not lay the cord under a carpet. Do not lay rugs, mats or similar
articles on it. Position the cord so that it does not pose an obstruction
or a tripping hazard.
3. Never pull the plug out of the socket at the cord!
4. Always disconnect the mains plug when the appliance is not in use.
Attention! The appliance may only be used for normal domestic use and not
for industrial purpose.
Before use
1. Before use, remove all packaging and inspect the appliance for any
damages. If there are appears to be any damages, please take back to
place of purchase for a replacement.
2. Ensure that all the accessories are included as per diagram above before
you can continue with the installation.
3. Ensure that the location of the heater installed is not directly under
a power socket and that a power socket is available to power the
appliances for use.
4. Refer to the installation guide for further instruction.
Batteries (remote control)
The remote control use one button cells, model No. CR2025 (3 V). We
recommend the use of Lithium type battery for longer use.
Note: Please follow battery disposal instruction on battery packaging, or
contact your local councils for safely disposal of batteries.