Whirlpool LGC1330ADW Manual De Instalación página 12

Orifice Conversion
1. FROM NATURAL GAS TO LP/PROPANE GAS:
a. Change the appliance pressure regulator from
natural to LP setting. (See figure 10, 11 or 12).
b. Screw the burner orifice hoods down tight against
the pins. (See figure 13B). Use care to not over
tighten. Over tightening can damage the coaxial pin
inside the orifice hood.
c. Models with standing pilots: Adjust burner pilots.
(See figure 5). Turn the selector switch on the face of
the thermostat to the LP position.
d. Adjust burner air shutter to the widest opening that
will not cause the flame to lift or blow off the burner
when cold.
NOTE: Correctly adjusted sealed burners, can have
flames that will lift or blow without a pot over the
burner. These should be adjusted with a pot in place.
FIGURE 13A
NATURAL GAS
SETTING
FIGURE 13B
LP GAS
SETTING
-12-
2. FROM LP/PROPANE GAS TO NATURAL GAS:
a. Change the appliance pressure regulator from LP to
natural setting. (See figure 10, 11 or 12).
b. Screw the burner orifice hoods away from the pins.
(See figure 13A). Approximately 1 1/2 to 2 turns.
c. Models with standing pilots: Adjust top burner pilots.
(See figure 5). Turn the selector switch on the face of
the thermostat to the Nat. position.
d. Adjust burner air shutter to the widest opening that
will not cause the flame to lift or blow off the burner
when cold.
NOTE: Correctly adjusted sealed burners, the flame
will lift or blow without a pot over the burner. These
should be adjusted with a pot in place.
Service - Parts Information
WHEN YOUR COOKTOP REQUIRES SERVICE OR
REPLACEMENT PARTS, CONTACT YOUR DEALER OR
AUTHORIZED SERVICE AGENCY. PLEASE GIVE THE
COMPLETE MODEL AND SERIAL NUMBERS OF THE
COOKTOP WHICH IS LOCATED ON THE COOKTOP
MODEL NUMBER PLATE.