LUND 47021204 Manual Del Usuario página 6

4. Next, select (1) Tube Mounting Bracket, (Figure 8). Bolt the Bracket to the end of the Bull Bar with (2) 8mm
x 35mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figure 9). Leave hardware loose
at this time. Repeat this Step to install the passenger side Tube Bracket.
(Fig 8) Bull Bar Tube Bracket
5. With help, position the Bull Bar with Tube Brackets up to the inside of the Mounting Brackets. Use the
included (4) 12-1.75mm x 35mm Hex Bolts, (8) 12mm Flat Washers, (4) 12mm Lock Washers and (4)
12mm Hex Nuts to attach the Tube Brackets to the Mounting Brackets, (Figures 9 & 10). NOTE: On
vehicles with tow hooks, insert the 12mm rear Hex Bolt through the rear hole in the Mounting Bracket, the
Tube Bracket in the middle and out through the flat end of the Support Bracket, (Figure 7). Do not tighten
hardware at this time.
Driver side Support Bracket in "no tow
hook-no bumper support" position
Fig 10
Attach each Tube Bracket to
the end of the Bull Bar with:
(2) 8mm x 35mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
Driver Side Installation Pictured
Front
(2) 12mm x 35mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
Fig 9
Page 6 of 24
I-Sheet Number 10777 Rev.B
3-1/2" OVAL BULL BAR
09-15 DODGE RAM 1500
(1) 10mm x 35mm Hex Bolt
(2) 10mm Flat Washers
(1) 10mm Lock Washer
(1) 10mm Hex Nut
03/08/16