LUND 471732 Guia De Inicio Rapido

Inspection After Installation
1. Make sure that the harnesses are not caught in other parts and that all of the vehicle parts
are properly installed.
2. After installation is complete, confirm its operation, according to the owner's operation guide.
Care and Cleaning
1. Avoid the use of automatic "brush-style" car washes.
2. Do not use cleaning solvents of any kind.
3. Wash only with mild soap and dry with a clean cloth.
4. Do not use wing as a handle.
5. Do not pull on wing to close rear hatch lift gate.
6. If you are carrying items on the roof of your vehicle, do not lay items on the wing
or use it as a tie-down.
7. Periodically check all components for tightness.
Congratulations!
You have purchased one of the many quality Lund® branded products offered by Lund International,Inc.
We take the utmost pride in our products and want you to enjoy years of satisfaction from your
investment. We have made every effort to ensure that your product is top quality in terms of fit,
durability, finish, and ease of installation.
Lund International, Lund Accessories Division
775 Tipton Industrial Drive, Building 2, Suite F
Lawrenceville, GA 30045
800-328-5863 • Fax 800-782-5448 • Visit us at lundinternational.com
© 2004 Lund International, Inc. All rights reserved.
Lund® and the Lund® logo are trademarks of Lund International, Inc.
45046
Rev. A
Page 4 of 4
Installation Instructions
Tiger and Super Tiger Wing
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Service at 1-800-328-5863.
Important Safety Information
CAUTION - Before driving, insure that the wing is properly anchored to the vehicle.
Contents
T-Strip
Wing
Wire Splice *
Brake Light *
* These items only included in lighted wing.
Tools Required
Safety Glasses Silicon
Socket Set Tape Measure
Preparation Before Installation
Wash the trunk lid using hot soapy water. Rinse and dry with clean towel.
45046
Rev. A
Part Numbers: 471732
Gasket Mounting Mounting
Nut Stud
Grommet * Brake Light Brake Light
Screw * Rubber Washer*
Drill 1/16" (1.5mm) 5/16" (8mm) 3/8" (10mm)
Drill Bit Drill Bit Drill Bit
Screw Driver Screw Driver Masking Tape
Page 1 of 4
481732
481714
Wire Tie *
Brake Light
Washer*
3/4" (19mm)
Drill Bit