Rough-In Electrical - Best IM33I45SP Manual Del Usuario

STRUCTURAL.REQUIREMENTS
The total weight of the hood is 40 lbs as supplied. Special structural considerations
must be made to ensure proper installation. The mounting brackets need to mount
to 2" nominal lumber. Hollow wall anchors should not be used at any time. Fig. 5.
ROUGH-IN DETAILS
2. X. 4. MINIMUM
FRAMING
INCOMING
POWER.
LOCATION
MOUNTING
HOLES. (5)
OUTLINE
OF. HOOD
MOUNTING. PLATE

ROUGH-IN ELECTRICAL

This hood is has a three prong plug. Incoming power should be located as shown
on the drawings above.
.WARNING: Electrical.wiring.must.be.done.by.a.qualified.person.in.accor-
dance.with.all.applicable.codes.and.standards.
3-3/4" 3-3/4"
- 8 -
7-1/4"
6-3/16"
1-7/16"
6". DUCT
LOCATION
FIG.. 5