Setting The Gain For Synced Amplifier; Quick Setup Of The Gain; Advanced Setup Of The Gain; Connecting The Speaker Wires - Pioneer PRS-D5000SPL El Manual Del Propietario

Connecting the Unit
Setting the Gain for
synced amplifier
After connecting the speaker wires, adjust each
synced amplifier's gain control. All synced ampli-
fiers follow the master amplifier's settings.

Quick Setup of the Gain

Set each synced amplifier's gain control to the
NORMAL position. This setting will balance output
volumes sufficiently for most applications.

Connecting the Speaker wires

Connect the speaker leads to suit the configuration according to the figures shown below and the next page.
Single Amplifier
• Speaker wire size must be 10 AWG minimum.
• Load may be any combination of speakers but impedance must be 2 Ω or larger.
MODE SELECT switch must be in
MASTER position.
9

Advanced Setup of the Gain

Starting with the master amplifier, adjust the gain
control on each amplifier in order.
1. Output sin wave through this system at low out-
put level.
2. Use volt meter to measure the master amplifier's
output voltage level.
3. Use volt meter to measure the synced amplifier's
output voltage level.
4. Match the synced amplifier's output to the mas-
ter's output using the gain control on the synced
amplifier.
5. Repeat for the each synced amplifier in the proper
order.
2 Ω
minimum
1,500 W