Stopping The Lawn Mower; Disconnecting The Battery - Oregon 120V Professional Serie Manual Original De Instrucciones

Ocultar thumbs Ver también para 120V Professional Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If needed turn the red knob 2 turns clockwise
Verify the drive position of the control bar by
operating the lawn mower If needed repeat the
adjustment
When operating the transmission
control bar (1) typical movement
on the red adjustment knob (3)
should be between 1/4" to 3/8"
(6 to 10 mm)
Notice: The red knob can be turned without
removing belt cover Pull out [the red knob and
turn
HEIGHT ADJUSTMENT
Each wheel can be adjusted individually to a
specific cutting height from 1 inch to 4 5 inch
Notice: It is only possible to move the
adjustment on one side 2 - 3 steps each
time.
Moving the front wheel height adjusters
forward raises the cutting height Moving the
rear wheel height adjusters towards the rear of
the lawn mower raises the rear cutting height
Always adjust the height adjusters to the same
position both in the front and the rear for best
cutting results
WARNING:
STOP the engine before
making any height adjustment.
Low 1" (25 mm)
7 steps - 1/2" (13 mm)
High 4.5" (114 mm)
16
Operation
WARNING:
height while the engine is running. STOP
the engine. Never lift the lawn mower by
placing your hand or fingers under the edge
of the mower deck.
MODES OF OPERATION
This lawn mower is approved to be used in two
2
different operational modes:
1 WITH A GRASS CATCHER IN PLACE
1
An original equipment Oregon catcher
has been tested to be used with this lawn
mower It is important to always inspect the
catcher for deterioration If the material is
3
ripped or worn the bag shall not be used
2 WITH THE MULCH PLUG INSTALLED
If the mulch plug is installed ensure that the
rear door can close completely
WARNING:
mower without the mulch plug or the grass
catcher in place. Never attempt to operate
the lawn mower with the rear door
removed, damaged, or propped open.

Stopping the Lawn Mower

• Release the upper engine control bar to stop
the lawn mower
WARNING:
the tool before transporting or performing
any maintenance on the lawn mower.

Disconnecting the Battery

Release the engine control bar to ensure that
the lawn mower is off and pull the battery plug
from the power socket
Never readjust the cutting
Do not operate the lawn
Disconnect the battery from
Lawn Mower Model LMA120VX-NA

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lma120vx-na

Tabla de contenido