After Operation - Nilfisk Advance PS 333A Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
may damage the floor. Depending on the flooring and
type of dirt you might have to check and clean the
brush or pad during scrubbing/polishing. Unplugg
the machine, demount the pad or brush and rinse it in
warm water. Both sides can be used on the pad. Use the
transportation wheels when moving the machine when
it is not running.
Caution! Do not run over the lead; it is a good idea
to carry the lead over your shoulder to protect it and
prevent accidents.

After operation

. Unplugg the machine.
. Clean the solution tank. Place the solution hose in a
drain and rinse the tank while the fluid valve is kept
open. Keep the valve open and rinse until the tank is
clean. If there is no drain avaliable, dismount the tank
and clean it in a suitable place.
. Dismount the padholder or brush. Never leave the
padholder or brush mounted on the machine. It may
destroy the brush/padholder.
. Clean the brush or pad and the padholder.
. Wipe the lead as you are coiling it. Use the hook (pos.4
on picture 1) and the handle to coil the mains lead.
Always coil from the machine to the plug, this is to
prevent the lead from
getting entangle.
Accessories
Brushes and pads
Brushes
Scrubbing brush
Polish/schampoo
Steel brush
Pads
White
Red
Blue
Brown
Plastic,linoleum
Polishing/carpet
schampooing
Concrete floor a.s.o
Polishing
Lightly soiled floors
Heavily soiled floors
Polish removal
13

Publicidad

Tabla de contenido
loading

Tabla de contenido