Installation Before Use; Part Name; Notice Before Use - EAS ELECTRIC EMTD7EC Manual De Instrucciones

Safety information
10. The lint trap has to be cleaned frequently.
11. The lint must not to be allowed to accumulate around the tumble dryer.
12. Adequate ventilation has to be provided to avoid the back flow of
gases into the room from appliance burning other fuels, including open
fires.
13. WARNING: never stop a tumble dryer before the end of the drying
cycle unless all items are quickly removed and spread out so that the heat
is dissipated.
14. The exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliance burning gas or other fuels.
15. The appliance must not be install behind a lockable door, a sliding
door or a door with a hinge on the opposite side to that of the tumble
dryer. In such a way that a full opening of the tumble dryer door is
restricted.
16. Keep pets away from this appliance.
17. Oil-affected items can ignite spontaneously, especially when exposed
to heat sources such as in a tumble dryer. The items become warm,
causing an oxidation reaction in the oil. Oxidation creates heat. If the heat
cannot escape, the items can become hot enough to catch fire. Piling,
stacking or storing oil-affected items can prevent heat from escaping and
so create a fire hazard.
18. If it is unavoidable that fabrics that contain vegetable or cooking oil or
have been contaminated by hair care products be placed in a tumble dryer
they should first be washed in hot water with extra detergent-this will
reduce, but not eliminate, the hazard.
19. The appliance should not be overturned during normal use or
maintenance.
20. Remove all objects from pockets such as lighters and matches
21. This appliance is for indoor use only.
.
2

Installation before use

Part name

1.Top board 2.Control panel 3.Door 4.Front panel 5.Side panel 6.Filter 7.Flex tube 8.Power plug
9.Switch 10.Tumbling box

Notice before use

The first step: Power source and grounding.
The dryer employs alternative current with the rated voltage and frequency. When the voltage
fluctuates between 6% of rated voltage, the dryer can work normally. A special power socket for
the dryer had better be set beside the dryer for convenience and safety. The method of
connection of the socket is as the figure below.
To be safe, please make improvements as soon as possible
according to the rules and suggestions mentioned above.
Notices:
The socket and the grounding wire must be installed by an electrician to prevent incorrect
installation or use of the socket and to guarantee the safety of use of electricity. The power wire
of the dryer employs Y connection, if the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. No
connection of the grounding wire the neutral wire, otherwise the cabinet will be charged, which
is likely to cause the danger of electric shock.
V.1
3 V.1