Technical Data - Stalgast KGPG-4 Serie Manual De Instrucciones

2.2. Characteristics of construction of the unit
Gas stoves of the KG series are manufactured in versions equipped with two, four or six burners. They
have a casing body and a removable bowl located under the burner, made of stainless steel, and high-power
gas burners with flame stabilization. The applied gas cocks enable gas transmission to the control (pilot)
burner and to the main burner. The main burner will not be actuated if the control burner (pilot) is not in
operation and the gas leak detector is not heated. In the event of a temporary fadeaway of flame, the gas
leak detector will cut off the gas supply to the burner. The amount of gas flowing into the main burner is
regulated by a gas cock, which enables the burner to obtain a flame in the range of: from full flame (full
power) to minimum flame (~1/3 of full power).
Stoves can be equipped with a grate made of cast iron or flat steel bar, enamel or stainless. They are
equipped with a connecting end with R1/2 thread. Each grate over the burner can be loaded with a
maximum of 100 kg of cookware
3.

TECHNICAL DATA

3.1. Adjustable stove
Unit's equipment (page 2): 1 - pilot panel, 2 - pilot knob, 3 - Grate
Stove Dimensions
model [mm]
9705110
400x700x250
9705130
(Figure 2a)
9705210
9705230
9706110
9706130
9706210
800x700x250
(Figure 3a)
9706230
9706310
9706330
9707110
9707130
1200x700x250
(Figure 4a)
9707210
9707230
Figure 5. Location of burners in the two-burner stove (schematically)
Burners installed to the
stove [kW]
3,5 + 5
3,5 + 7
3,5 + 2 x 5 + 7
3,5 + 5 + 2 x 7
2 x 5 + 2 x 7
3,5 + 3 x 5 + 2 x 7
3,5 + 2 x 5 + 2 x 7 + 9
9705130, 9705110
- 41 -
Location of
burners
Figure 5
Figure 6
Figure 7
9705230, 9705210
Total power
[kW]
8,5
10,5
20,5
22,5
24
32,5
36,5