Electrical And Structural Requirements; How To Assemble Your Floor Fan - Fanimation ARDEN FP8014 Serie Manual Del Usuario

Electrical and Structural Requirements

ELECTRICAL REQUIREMENTS
Table / Wall fan requires a grounded electrical supply line
of 120 volts AC, 60 Hz, 15 amp circuit. 8 ft power cord
included. NOT for Damp Location Use.
WARNING
To Avoid Fire Or Electrical Shock, Do NOT Use This Fan
With Any Solid-State Speed Control Device And Do NOT
Use By Open Window.
1. Assemble the leg to the motor assembly with
3/16˝-24 x 1/2˝ screws. Make sure all screws securing
tight the leg with motor assembly using the supplied
"T" wrench. (Figure 1)
2.
Assemble the cap rubber on to the screw of the leg.
(Figure 2)

How to Assemble Your Floor Fan

To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Motor Assembly
HARDWARE USED:
3/16"-24 x 1/2"
Cap Head With
Spring Washer
Cap Rubber
5
WARNING
Leg
Figure 1
x 12
Figure 2