Publicidad
Idiomas disponibles
Idiomas disponibles
1. Lower exhaust - use 13mm socket to remove (2) bolts that connect exhaust hanger bracket to the
frame (each side). Use exhaust support stand to prevent damaging muffler.
2. Loosen lower fasica– use 8mm socket to remove (4) lower fascia support fasteners and press down the
tabs to detach bottom plastic panel as shown in Figure 2.
4. Remove (1) rubber square plug from each frame rail. Return it to owner. Detach (3) vehicle wiring
plastic fasteners from frame rail both sides, using a screwdriver or trim panel tool. NOTE: On Trailhawk
models remove (2) existing M14 bolts from the rear vertical and horizontal frame on each side. Keep
them for reassembly.
Trailhawk
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. NOTE: On Trailhawk models remove (4) extra plastic rivets that secure the heat shield around lower fascia and
take the heat shield down as shown in Figure 3.
3. Locate center line of lower fascia and trim 4.5'' tall and 3.5'' wide, as shown in Figure 4.
Trailhawk
Trailhawk
Trailhawk
5. Feed the carriage bolt ① and spacer ② through access square hole using the pull wires ⑧ for both
vertical and horizontal slots, as shown in Figure 5. Leave pull wires attached. NOTE: On Trailhawk models
only feed (1) vertical hardware through forward square slot and reuse (2) M14 bolts removed in step 4
each side.
Sheet 4 of 15
75998NP
Trailhawk
3.5''
4.5
04-14-15
Rev. A
Publicidad
