Fan Assembly. Pgs - Craftmade Copeland Guia De Instalacion

5. Fan Assembly (with downrod). (cont.)
safety cable loop
wood
With the hanging bracket secured to the outlet box
ceiling
and able to support the fan, you are now ready to
joist
hang your fan. Grab the fan firmly with two hands.
wood screw
Slide downrod through opening in hanging bracket
and washer
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab.
safety cable
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in serious
hanging bracket tab
injury or death.
hanging ball slot
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
motor housing
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw, washer
and lock washer (not supplied) with the safety cable
loop. If necessary, adjust the loop at the end of the
canopy
safety cable. The loop at the end of the safety cable
should just fit over the threads on the wood screw.
Test safety cable by pulling on loose end with pliers. If
canopy cover
the safety cable slips, the cable must be pulled tighter.
Extra cable slack can be left in ceiling area.
canopy
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal 6 holes.
Notice that 3 of these holes are larger.
canopy ring
Note: Yoke cover is not used with this type of
set screw
installation.
pin
If there are only 3 screws in top of motor housing,
please proceed to next paragraph. If there are
clip
6 screws in top of motor housing, remove every
other screw and lock washer.
yoke
Remove pin, clip and set screws from motor housing
yoke. Thread wiring through canopy ring and canopy.
Place canopy over yoke, aligning larger holes in
motor housing
canopy with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock washers that
had been removed (if there were only 3 screws
located in top of motor housing, these screws/lock
washers will be located in one of the hardware
packs) into the remaining holes. Securely tighten
these screws.
canopy
To prepare the fan for wiring, hang fan onto hanging
bracket by sliding the canopy over the hanging
hanging bracket tab
bracket tab. (Use one of the non-slotted holes on the
motor housing
rim of the canopy to do so.)
page 5