Dash Disassembly - Metra 99-9107B Instrucciones De Instalación Para

Dash Disassembly

1. Insert Metra's 86-9001 radio
removal tools into the slots in the
factory radio and pull the radio out.
(Figure A)
2. Disconnect the wiring.
CD LOAD
AS
FM MENU
AM TONE
SAT RDS
TAPE SCAN
(Figure A)
®
99-9107B
DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the DIN sleeve into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Snap the included pocket into the
Radio Housing until secure. (Figure C)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
6. Install the assembled kit assembly
into the dash.
ATTENTION:
Once the dash kit is
snapped in, it cannot be removed
without dash panel removal
2
Kit Assembly
(Figure A)
(Figure B)
(Figure C)