Install The Handles - Kohler K-T7019 Guia De Instalacion

Plug
Button
Screw
Handle
Assembly

4. Install the Handles

NOTE: The handle assembly shown may differ from your actual
product. The installation instructions still apply.
Insert a washer into the underside of each escutcheon.
Thread each escutcheon over each valve stem until it is snug
against the finished surface.
Slide a spline adapter half way down each valve stem.
Gently press the handle assembly marked "cold" with blue tape
onto the spline adapter on the right.
Gently press the remaining handle assembly onto the spline
adapter on the left.
Check for proper alignment of each handle assembly. If necessary,
remove the handle assembly, reposition the spline adapter on the
valve stem, then reinstall the handle assembly.
For vandal-resistant handle assemblies: Insert each
vandal-resistant button into the top of each handle assembly.
Right is blue; left is red.
Secure the handle assemblies with a screw.
For regular handle assemblies: Press the plug button over the
screw.
1011303-2-C
Vandal-Resistant
Screw
Vandal-
Resistant
Button
(Red/Blue)
Spline
Adapter
Valve Stem
Escutcheon
Washer
6 Kohler Co.