Viega PureFlow Instrucciones

Product Instructions
Viega PureFlow Press
®
Port Adapter
1 2
B
A
7
C
EN
Viega PureFlow Press Port Adapter
Zero Lead ManaBloc Port Connection
®
Viega products are designed to be
installed by licensed and trained plumbing
and mechanical professionals who are
familiar with Viega products and their installation.
Installation by non-professionals may void
Viega LLC's warranty.
Zero lead identifies Viega products meeting
the lead free requirements of NSF 61-G
through testing under NSF/ANSI 372 (0.25%
or less maximum weighted average lead content).
The water supply to the ManaBloc shall be
turned off before attempting installation of
press supply adapters.
Viega LLC
585 Interlocken Blvd.
Broomfield, CO 80021
Phone (800) 976-9819
www.viega.us
3 4
CAUTION!
Use only supplied sealing element.
1
Ensure sealing element (A) is in place and the tool
locator ring (B) is present in its factory installed
position.
2 Square off tubing to proper length and insert the
fitting fully into the end of the tubing as shown. Full
insertion means tubing must be completely visible
in at least two viewing holes and may be partially
visible in one.
3
Placing the PureFlow Press tool jaw over the
attached press sleeve resting it against the tool
locator ring. Press the sleeve with an appropriately
sized press jaw. Refer to current Viega PureFlow
Water Systems Manual for additional pressing
information.
CAUTION!
Do not press twice.
EN
Product Instructions
Viega PureFlow Press Port Adapter
This document is subject to updates. For the most current Viega
technical literature please visit www.viega.us.
ES
Instrucciones del Producto
Adaptador de puerto prensado
PureFlow de Viega
Este documento está sujeto a actualizaciones. Para consultar la más
reciente literatura técnica de Viega visitar www.viega.mx.
FR
Directives du Produit
Adaptateur de port PureFlow Press
de Viega
Ce document est soumis à des mises à jour. Pour consulter les
manuels techniques Viega les plus récents, consultez notre site
www.viega.ca.
PI-PF 521116 1119 PureFlow Press Port Adapter (EN ES FR)
5
B
A
C
4
Remove tool locator ring (B) and slide swivel nut
(C) over tubing as shown.
5
Ensure sealing element (A) is in place and clean
of any dirt or debris. Wet sealing element with
tap water.
6
Insert the fitting into the desired port until the
fitting flange sets flush with the end of the port.
7 Thread the swivel nut (C) onto the ManaBloc port.
Hand-tighten only. Open the port valve(s) before
turning on the main water supply.
6